@article{oai:toyama.repo.nii.ac.jp:00003346,
 author = {Kazamaki, Tsuneji},
 issue = {112},
 journal = {Bulletin of JSME},
 month = {Oct},
 note = {application/pdf, In the last reports, assuming that the surface irregularities of specimens were isotropic and had a form of similar truncated cone whose deformations were elastic, plastic and elasto-plastic, the analytical solutions of equivalent gap for the fluid leakage between contact surfaces were verified with the experimental results using a lapped carbon steel. In this paper, the specimens, which are finished by lathing and grinding, are axamined. The results obtained can be summarized as follows : (1) In the case in which the phenomenon of leakage was a radial and sector flow, the experimental values of equivalent gap obtained by assuming the surface roughness as anisotropic were in agreement with the analytical values with deviation about 8 %. (2) The characteristic curves of parameters a and b for the carbon steel listed in the 2nd report can be applied for the materials tested in this experiment., Article},
 pages = {1321--1331},
 title = {An Investigation of Air-leakage between Contact Surfaces : 3rd Report, On Case in which Cast Iron and Brass were used as Specimen},
 volume = {17},
 year = {1974}
}