@article{oai:toyama.repo.nii.ac.jp:00016014,
 author = {堀江, 秀夫},
 journal = {GEIBUN : 富山大学芸術文化学部紀要, Bulletin of the Faculty of Art and Design University of Toyama},
 month = {Feb},
 note = {The purpose of this research is to use the remnant of 24mm and 28mm-thick Structural Plywood discharged from factories of prefabricating system, as material for hand-made furniture.
　I studied about the kind, bending strength properties and connecting properties of the remnant.
　The results of the tests are summarized as follows.
　The remnant in Toyama prefecture is two kinds of thicknesses (24mm, 28mm) and three kinds of species of veneer (a Japanese cypress, a larch, a Japanese cedar). These confirmed the free of charge and available thing if they could obtain consent on the side of the factory.
　From results of bending test of five kinds pieces of the remnant in Toyama prefecture, there was strong linear relationship between Youngʼs modulus and bending strength. Therefore, like the lumber, the stress-grading
is possible. Also, in case of small section member in the remnant , there is not a problem on the bending strength.
　24HS remnant (thickness:24mm, surface layers: Japanese cypress, core layers: Japanese cedar) were comparatively many emissions and smoothness of the surface. Therefore, it should design hand-made furniture, presupposing that it uses 24HS remnant.
　From results of strength test of joints which used two Coarse-threaded screws (CTS) with length from 45mm to 90mm and 24HS remnant of 60mm width, CTS of 65mm length suited as connector of chair. The shortterm allowable moment resisting of this connector was estimated to be 33 N･m.
　Also, from results of strength test of joints which used two dwel-joints (10mm diameter, 60mm length) and 24HS remnant of 50mm width, the short-term allowable moment resisting of this connector was estimated to be 51 N･m., Article, GEIBUN : 富山大学芸術文化学部紀要, 12号, 2018.02.28, Page 70-85},
 pages = {70--85},
 title = {プレカット工場から排出される厚物構造用合板端材の曲げ強度性能と家具仕口を想定した接合性能の検討＊},
 volume = {12},
 year = {2018}
}